Sewing method of jacquard elastic band
2023-08-29
Jacquard elastic belt has the following seven kinds of sewing methods, let's take a look at it:
The first kind
1. Sew half of the cloth to form a tube
2. Open the seam and sew the edge of the cloth half the width of an elastic band. Leave 2cm in the center of the seam for wearing the elastic band.
3. Stacking and stitching the elastic band after the elastic band is penetrated. The jacquard elastic band used by this girl is wider than the force, so she used the box-type sewing method. If the force used by each person is narrower than the force, she can directly sew back and forth in a straight line after stacking. The following sewing method is that the elastic band is not stacked, and the Z-shaped sewing is directly used to sew a few stitches back and forth on the seam. At the end, just sew the elastic band.
Second Kind
Or first sew the cloth into a tubular shape, divide the cloth and elastic band into two equal parts, and use a needle firmly in the middle. Use Z-shaped jacquard elastic band to sew on the edge of the cloth, then fold the elastic band inside, sew a straight line, and remember to straighten the cloth when sewing
Third Kind
This one is similar to the sewing method behind the second one, except that a thin elastic band is used when sewing a line at the end, and the elastic band is gently wound on the shuttle. The elastic band is sewn on the reverse side of the cloth in the same way as the bottom line. After stitching is the effect of the last picture.
Fourth Kind
The required cloth must be a seam with a width of 2cm of the elastic band. First, half of the cloth is sewn, and then the sewn cylinder is turned over to the front with a pin. According to the first method, the elastic band is inserted into the back and the two ends are sewn firmly, which is the final effect.
The fifth kind
Two pieces of cloth are necessary. Draw the width of the elastic band on the upper piece of cloth, and stitch the two pieces of cloth along these two lines. Pierce the elastic band and sew the cloth end.
Sixth
First, draw the track of the necessary seam elastic band on the cloth, and then find out the middle point of the cloth and the elastic band respectively, that is, remember to align the middle point when the cloth is divided into two equal seams, and sew a straight line directly on the elastic band.
Seventh
First, draw the track of the elastic band to be sewn on the cloth, and sew a straight line directly on the cloth. The first one is better than the force. When sewing the back several pieces, the cloth should be tightened. This time, the fine elastic band should be used, but it should be tightened a little when winding the shuttle as the bottom line.
Official Website
Official Account
Page Copyright 2023 Quanzhou Baishengxin Weaving Co, Ltd. Power by www.300.cn Label